Table of Contents
Advertisement
VC73410MUK Rev4_Instruction Book 31/10/2012 11:18 Page 8
Cleaning under furniture in
Lift Away canister mode
This function is ideal for cleaning underneath low
furniture.
Separate the Lift Away canister
1.
motorised floor brush nozzle
Lift Away canister release button
of the Lift Away canister.
Press the extension tube release button
2.
pull the extension tube
Attach the end of the extension tube
3.
motorised floor brush nozzle
Floor attachment (30).
Certain
models
only
Press the On/Off 3-position switch
4.
position to turn the suction motor on.
NOTE: The rotating brush bar
in Lift Away canister mode.
Gently press the motorised floor brush nozzle
5.
down with your foot while you grasp the handle
(1)
and tilt it back towards you. Tip the unit
backwards to access under low furniture.
Adjusting suction power
When using the attachments, the suction may be
too powerful. Adjust the suction power by rotating
the suction adjustment collar
anti-clockwise to open the valve to reduce
suction. Less suction may be required for
cleaning delicate areas and upholstery.
8
(32)
from the
(23)
by pressing the
(19)
on the side
(9)
and
(8)
up.
(8)
to the
(23)
or Dust Away
(11)
to the "I"
(25)
will not rotate
(23)
(3)
90°
Suction
Release Collar
Rotate the collar clockwise to close the valve
when you need high suction and for vacuuming
floors.
Safety cut-outs
If the cleaner overheats, a motor protection
thermostat will automatically switch the motor off.
If this happens, switch the cleaner off, unplug
from the power supply and leave the cleaner to
cool for at least 90 minutes. Check the airways
for blockages, empty the dust canister and clean
the filters before restarting.
If the rotating brush bar
(25)
safety cut-out will stop the brush and the
motorised floor brush indicator light
change from green to red. If this happens, switch
off and unplug the product. Disconnect the
motorised floor brush nozzle and carefully remove
the blockage.
Maintenance
WARNING: Always unplug the vacuum cleaner
from the mains supply before undertaking any
of the following maintenance procedures.
Emptying the dust canister
Empty the dust canister
(13)
does not look full, this will maintain the
performance.
Unplug the cleaner from the mains switch.
1.
Undo the dust canister release latches
2.
each side of the Lift Away canister
them up and outwards.
Remove the dust canister from the motor base
3.
(18).
becomes jammed, a
(24)
will
regularly even if it
(16)
on
(32)
by lifting
Advertisement
Table of Contents
