1. Manuals
  2. Brands
  3. Broan Manuals
  4. Ventilation Hood
  5. Elite RMPE Series
  6. Instructions manual

Broan Elite RMPE Series Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Broan-NuTone LLC. 926 West State Street, Hartford, WI 53027
NuTone Inc., 4820 Red Bank Road, Cincinnati, OH 45227
Broan-NuTone Canada Inc.1140 Tristar Drive, Mississauga, Ontario L5T 1H9
RMPE Series
ENGLISH....................................2
FRANÇAIS...............................11
ESPAÑOL.................................20

Advertisement

Table of Contents
loading

Related Manuals for Broan Elite RMPE Series

Summary of Contents for Broan Elite RMPE Series

  • Page 1 RMPE Series ENGLISH........2 FRANÇAIS.......11 ESPAÑOL.........20 Broan-NuTone LLC. 926 West State Street, Hartford, WI 53027 NuTone Inc., 4820 Red Bank Road, Cincinnati, OH 45227 Broan-NuTone Canada Inc.1140 Tristar Drive, Mississauga, Ontario L5T 1H9...
  • Page 2 READ AND SAVE THESE INSTRUCTIONS INTENDED FOR DOMESTIC COOKING ONLY WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.
  • Page 3 11. Please read specification label on product for further information and requirements. 12. To reduce the risk of fire and electric shock, install this range hood only with Broan Exterior blower models 331H, 332H, 335 or 336, or Broan In-Line Blower models HLB3, HLB6, HLB9 or HLB11.

  • Page 4: Prepare The Hood

    PREPARE THE HOOD Unpack hood and check contents. You should receive: 1 - Hood 1 - Parts Bag (B080810168) containing: 4 - Mounting Screws (3,2 x 13mm) 1 - Installation Instructions 4 MOUNTING (3,2 x 13mm) SCREWS EXTERIOR OR IN-LINE BLOWER SELECTION CAUTION: Either an exterior blower or in-line blower may be used with this hood.

  • Page 5: Install The Ductwork

    INSTALL THE DUCTWORK NOTE: To reduce the risk of fire, use only metal ductwork. 1. Choose the location where the Exterior or In-Line Blower will be mounted. See illustrations below for mounting location suggestions and restrictions. 2. A straight, short duct run will allow the hood to perform most efficiently. 3.

  • Page 6: Install The Hood

    INSTALL THE HOOD KNOB 1. Remove the grease filters by pushing filter METAL GRILLE towards the back of hood and rotating filter downward. 2. Remove the metal grille by turning the (2) knobs counterclockwise. 3. Cut a hole in the bottom of the cabinet, using the dimensions shown.
  • Page 7 WIRING BLOWER CONNECTION AT HOOD Exterior or In-Line CAUTION: All electrical wiring should blower be done by a qualified person (s) in accordance with all applicable codes and standards. This range hood must be CONNECT: WHITE-TO-WHITE, properly grounded. RED-TO-BLACK, GREEN-TO-GROUND. Do not turn power on at service panel until all wires have been connected.

  • Page 8: Maintenance

    MAINTENANCE Proper maintenance of the Range Hood will assure proper performance of the unit. Grease Filters The grease filters should be cleaned fre- quently. Use a warm detergent solution. Grease filters are dishwasher safe. GREASE FILTERS Remove filter by pushing filter towards the back of hood and rotating filter downward.

  • Page 9: Operation

    OPERATION LIGHT BLOWER SWITCH SWITCH Controls The hood is operated using the slide controls under the bottom of the hood. The light switch turns the lamps on and off. The blower switch :makes it possible to select the motor operating speed. Position 0: motor off.

  • Page 10: Halogen Bulbs

    RANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OR MERCHANT ABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this one-year period, Broan-NuTone LLC will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

  • Page 11: Service Parts

    SERVICE PARTS MODEL RMPE - Parts for stainless steel models shown. For service parts for black, white, polished brass, or brushed copper models, call Broan Customer Service. KEY NO. PART NO. DESCRIPTION B003185305 GRILL B02011013 SPRING B08087153 GREASE FILTER B02300899...

  • Page 12: Lista De Piezas De Recambio

    SERVICE PARTS - LISTE PIECES DE RECHANGE - LISTA DE PIEZAS DE RECAMBIO MODEL RMPE 04307767...

This manual is also suitable for:

Rmpe series

Table of Contents