Operation Instructions - Landa Pgdc4-3500 Operator's Manual

High pressure
Nozzle
Wand
Coupler
Collar
STep 1: Read operator's manual
before operating. Pull wand cou-
pler collar back, insert desired
pressure nozzle into coupler, then
secure by pushing collar forward.
CAUTION: Never replace nozzles
without engaging the safety latch
on the spray gun trigger.
STep 4: With the spray nozzle
pointed away from you or anybody
else, press the trigger on the spray
gun to obtain pressurized cold water
spray.
brass Soap
Nozzle
High
pressure
Nozzle
STep 6: Selection of high or low pressure is accompanied by turning the
handle. NOTe: High pressure nozzle must be inserted at end of wand to
obtain high pressure.
To apply detergent, place detergent pick-up tube into a container of deter-
gent and turn the detergent valve counterclockwise.
8

OpeRaTION INSTRUCTIONS

8916596-5
STep 2: Turn on water at faucet
and pull trigger on spray gun al-
lowing water to flow until all air has
discharged from system. Check for
water leaks; tighten as needed.
NOTe: Variable pressure control
wand handle must be turned clock-
wise to enable water to flow out of
the high pressure nozzle.
burner
Switch Detergent
8916596-3
STep 5: For hot water, turn the
burner switch to ON when a steady
stream of water flows out of the
spray gun. Burner will now light
automatically. NOTe: Do not start
machine with burner switch on.
Variable pressure
Wand (Vp)
Variable pressure
Control Handle
LANDA PGDC • 8.916-596.0 •
8916596-6
8916596-15
Valve
Trigger
8916485-2
REV. 5/13
engine
Switch
STep 3: Read engine manual.
Move fuel valve to closed or OFF po-
sition, if equipped. To start engine,
if choke is closed, gradually move it
to the open position as the engine
warms up. Turn the engine switch to
the START position and hold it there
until the engine starts.
NOTe: Do not use the electric
starter for more than five seconds
at a time. If the engine fails to start,
release the switch and wait ten
seconds before operating the starter
again. When the engine starts, allow
the engine switch to return to the ON
position. If the engine is to be started
without the battery, turn switch to
start position and pull rope to start.
Turn off choke.
CAUTION: Small engines may
kick back. Do not hold pull rope
tightly in hand.
8916596-14