Operation Instructions - Landa PGDC Series Operator's Manual

Operation Instructions

High Pressure
Nozzle
Wand
Coupler
Collar
STEP 1: Read operator's manual
before operating. Pull wand coupler
collar back, insert desired pressure
nozzle into coupler, then secure by
pushing collar forward.
CAUTION: Never replace nozzles
without engaging the safety
latch on the spray gun trigger.
STEP 4: With the spray nozzle
pointed away from you or anybody
else, press the trigger on the spray
gun to obtain pressurized cold
water spray.
Brass Soap
Nozzle
High
Pressure
Nozzle
Variable Pressure
STEP 6: Selection of high or low pressure is accompanied by turning the
handle. NOTE: High pressure nozzle must be inserted at end of wand to
obtain high pressure.
To apply detergent, place detergent pick-up tube into a container of
detergent and turn the detergent valve counterclockwise.
STEP 2: Turn on water at faucet
and pull trigger on spray gun
allowing water to flow until all air
has discharged from system.
Check for water leaks; tighten as
needed. NOTE: Variable pressure
control wand handle must be
turned clockwise to enable water to
flow out of the high pressure
nozzle.
Burner
Switch Detergent
STEP 5: For hot water, turn the
burner switch to ON when a steady
stream of water flows out of the
spray gun. Burner will now light
automatically. NOTE: Do not start
machine with burner switch on.
Variable Pressure
Wand (VP)
Control Handle
Landa PGDC Operator's Manual 8.916-596.0 - P
Valve
Trigger
Operations
Engine
Switch
STEP 3: Read engine manual.
Move fuel valve to closed or OFF
position, if equipped. To start
engine, if choke is closed, gradually
move it to the open position as the
engine warms up. Turn the engine
switch to the START position and
hold it there until the engine starts.
NOTE: Do not use the electric
starter for more than five seconds
at a time. If the engine fails to start,
release the switch and wait ten
seconds before operating the
starter again. When the engine
starts, allow the engine switch to
return to the ON position. If the
engine is to be started without the
battery, turn switch to start position
and pull rope to start. Turn off
choke.
WARNING: Small engines may
kick back. Do not hold pull rope
tightly in hand.
Starter cord kickback (rapid
retraction) can result in bodily
injury. Kick back will pull hand
and arm toward engine faster
then you can let go. Always
relieve spray gun pressure
before pulling starter cord.
Pull starter cord slowly until
resistance is felt, then pull
rapidly.
11