Using Your Light & Easy™ Steam Mop - Shark S3251 Owner's Manual

Using Your Light & Easy™ Steam Mop
fig. 1
fig. 2
IMPORTANT: Your steam mop needs
water to make steam! Never use your
steam mop without water in the tank.
Sweep or vacuum your floors prior
to cleaning with your Light & Easy™
Steam Mop.
Visit www.sharkclean.com for other
great quick cleaning products to
complement your Light & Easy™
Steam Mop, such as the Shark
Navigator.
6 TOLL FREE: 1-800-798-7398
When you use your steam mop for the
first time or if you have not used the unit
in awhile, it may take a minute or two
for the water to travel through the pump
and into the heater to create steam. Get
it started by pumping the handle a few
times. If you have waited a few minutes
and you still do not see any steam,
reference the troubleshooting section
on page 10.
fig. 3
1
Pull and twist the quick release
cord holder to unwrap the power
cord completely. (fig. 1) Plug into
an electrical outlet. (fig. 2) The
"On" light will turn blue. If the light
does not turn on, reference the
troubleshooting section on page 10.
(fig. 3)
®