Shark Steam Lite S3250UKJR Owner's Manual
  1. Manuals
  2. Brands
  3. Shark Manuals
  4. Steam Cleaner
  5. Steam Lite S3250UKJR
  6. Owner's manual
Shark Steam Lite S3250UKJR Owner's Manual

Shark Steam Lite S3250UKJR Owner's Manual

Steam mop
Hide thumbs
Table of Contents

Advertisement

Quick Links

STEAM LITE
S3250UKJR
OWNER'S GUIDE

Advertisement

Table of Contents
loading

Related Manuals for Shark Steam Lite S3250UKJR

Summary of Contents for Shark Steam Lite S3250UKJR

  • Page 1 STEAM LITE S3250UKJR OWNER’S GUIDE...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK 1. Use the system only for its ® intended use. STEAM MOP, BASIC SAFETY 2. DO NOT use outdoors. PRECAUTIONS SHOULD 3. DO NOT leave the appliance ALWAYS BE FOLLOWED, unattended when plugged in. INCLUDING THE FOLLOWING: Always unplug the power cord from the electrical outlet when not WARNING: in use and before servicing. 4. DO NOT allow the appliance to be REDUCE THE RISK OF FIRE, used as a toy. Close attention is...
  • Page 3 11. DO NOT unplug by pulling on 22. Never use steam mop without power cord. To unplug, grasp the microfibre pad attached. plug not the power cord. Do not 23. Keep your work area well lit. use extension cords or outlets with inadequate current carrying 24. Store steam mop indoors in a cool, capacity. dry place. 12. DO NOT put any objects into 25. To avoid circuit overload, do not openings. Do not use with any operate another appliance on the opening blocked. same socket (circuit) as the steam cleaner. 13. DO NOT put hands or feet under the steam mop. Unit gets very hot. 26. If an extension cord is absolutely necessary, an extension cord rated 14. Use ONLY on flat, stable horizontal a minimum of 15 ampere, 14 gage surfaces. Do not use on walls, cord should be used. Cords rated counters, windows, chairs or tables. for less amperage may overheat. 15. DO NOT use on leather, wax Care should be taken to arrange polished furniture or floors, cord so that it cannot be pulled or synthetic fabrics, velvet or other tripped over.
  • Page 4 Quick Start fig. 3 fig. 1 fig. 2 ASSEMBLE FILL 1 Fit together the extension tubes 3 Remove the cap to fill the water as shown in the illustration. tank. Use the filling flask and (fig. 1) funnel to fill the tank with water to the “MAX FILL” line. Replace 2 Place the microfibre cleaning pad the water tank cap. (fig. 3) underneath the mop head, with quick fastener strips facing up. Simply press the mop to the pad to attach it. (fig. 2)

  • Page 5: Steam Lite

    5 fig. 4 STEAM CLEANING BACKSAVER 4 Plug in the mop. Wait 30 seconds 5 Use the Shark Steam Lite ® for the unit to heat up and the with backsaver benefit to steam to be ready. access tight areas. Press the release button on the Push the handle toward the handle to lock the steam mop head in a pumping motion. mop in the backsaver Customise steam output by slow position. Press the release or fast mopping with a forward button on the handle again and backward motion. (fig. 4) to straighten the handle. (fig. 5)
  • Page 6 Guarantee: This product is unconditionally guaranteed for one year against all defects of workmanship and materials. This guarantee does not affect your statutory rights. If this product proves unsatisfactory please contact our customer service department on freephone 0800 781 7831. THIS BOOK COVERS MODEL NUMBER: S3250UKJR 11 TECHNICAL SPECIFICATIONS Voltage: 220-240V., 50Hz. Power: 1550 Watts Not to be disposed Water of with other household waste. IP44 Capacity: 250 ml (8 oz.) www.sharkclean.co.uk...
  • Page 7 Contents Thank you for GETTING STARTED purchasing USING YOUR STEAM MOP the Shark USING YOUR ACCESSORIES ® Steam Lite. STORAGE AND CARE OF YOUR STEAM MOP ORDERING REPLACEMENT PARTS TROUBLESHOOTING www.sharkclean.co.uk...

  • Page 8: Getting Started

    Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark Steam Lite steam mop. ® fig. 1 ASSEMBLY Upper Handle Tube with Backsaver benefit 1 Remove all the parts from the package. Verify all the listed parts Lower Tube are included. Steam Mop Base 2 Insert the long gray end of the lower 2 All-Purpose Cleaning Pads pole (a) into the Backsaver handle (b). Press gently until you hear them Filling Flask click into place. (fig. 1) Funnel Grooming Carpet Glider www.sharkclean.co.uk...
  • Page 9 fig. 2 3 Take the assembled pole and insert IMPORTANT: Never use the steam it into the base of the mop (c). Align mop without attaching a microfibre the notches and press gently until cleaning pad to avoid damage to your you hear it click into place. (fig. 2) floor and mop. www.sharkclean.co.uk...
  • Page 10 Getting Started - cont’d Your microfibre cleaning pads should be replaced every 3 months to maximise cleaning performance. fig. 1 ATTACHING THE MICROFIBRE PAD IMPORTANT: Only add water to the tank. Chemicals or cleaning 1 Place the microfibre cleaning pad solutions may be unsafe or cause on the floor with the quick fastener damage. strips facing up. Place the steam mop on the top of the pad to attach. (fig. 1) www.sharkclean.co.uk...
  • Page 11 fig. 2 FILLING THE WATER TANK 2 A filling flask and funnel are included with your steam mop to make filling IMPORTANT: Unplug the steam mop the water tank easy. Fill the flask with before filling the water tank with water and use the funnel to pour it water. into the tank. Keep the water level 1 Remove the water tank cap by under the “MAX FILL” line. (fig. 2) turning it counter-clockwise to the 3 Replace the water tank cap and turn unlocked position. (fig. 2) it clockwise to the locked position. www.sharkclean.co.uk...
  • Page 12 Using Your Shark Steam Lite Mop ® When you use your steam mop for the first time or if you have not used the unit in a while, it may take a minute or two for the water to travel through the pump and into the heater to create steam. Get it started by pumping the handle a few times. If you have waited a few minutes and you still do not see any steam, reference the troubleshooting section fig. 1 on page 12. fig. 2 IMPORTANT: Your steam mop needs 1 Pull and twist the quick release cord holder to unwrap the power water to make steam! Never use cord completely. (fig. 1) Plug into your steam mop without water in the a 220-240 volt electrical outlet. tank. The “On” light will turn blue. If the Sweep or vacuum your floors prior to light does not turn on, reference the cleaning with your steam mop. troubleshooting section on page 12. (fig. 2) www.sharkclean.co.uk...
  • Page 13 Steam Lite If your Shark ® steam mop stops steaming, it could be out of water. Unplug the power cord from the electrical outlet and refill the water tank at anytime. fig. 4 fig. 5 2 Wait 30 seconds for the boiler to 3 Mop with a forward and backward heat the water. Pump the handle motion to customise steam output a few times to prime the pump, automatically. (fig. 5) activate steam and moisten the microfibre pad. (fig. 4) www.sharkclean.co.uk...
  • Page 14 Using Your Shark Steam Lite Mop - cont’d ® fig. 1 1 Clean under furniture and tight Backsaver™ areas using the Shark ® locking handle. Press the handle release button and apply slight pressure to bend the handle. The Shark Backsaver™ joint will lock at ® a perfect, access-maximising angle. (fig. 1) 2 Press the release button on the handle again to straighten. www.sharkclean.co.uk...

  • Page 15: Using Your Accessories

    Using Your Accessories The Shark Steam Lite ® steam mop will not pick-up solid particles or hair from carpets or areas rugs, but it is great for deodorising and freshening carpet surfaces against tough odors. fig. 2 fig. 3 GROOMING CARPET GLIDER USING THE GROOMING CARPET GLIDER The steam mop is versatile. The carpet glider freshens and 2 Plug in the steam mop and begin freshening and grooming your carpet deodorises carpets and area rugs with the power of steam. by pushing the mop and glider back and forth to release steam. (fig. 3) ATTACHING THE CARPET GLIDER When finished, unplug the steam...
  • Page 16 Care of Your Shark Steam Lite Mop ® fig.2 fig.1 AFTER USE AND STORAGE 4 To store the cooled Shark ® Steam 1 When you have finished using the Lite steam mop, hang it on a large steam mop, unplug the cord from hook. (fig. 2) the outlet and place the mop into NOTE: If you want to store the steam the upright position and let the unit mop standing upright, make sure it cool 2-3 minutes. Release steam by is leaning against a wall for added pumping the handle several times. support and safety. Always store Carefully separate microfibre your steam mop with the microfibre cleaning pad from steam mop, cleaning pad removed. Store away avoiding contact with the hot pocket from children and high traffic areas.

  • Page 17: Ordering Replacement Parts

    Ordering Replacement Parts fig. 3 40° fig. 4 CARE OF YOUR MICROFIBRE ORDERING REPLACEMENT PARTS CLEANING PAD To order additional parts and 1 Wash pads in warm water. Wash accessories, feel free to contact us at separately from other laundry. JML, Unit 1 Eastside Only use liquid detergent (no powder Port of Tyne detergent). Do not use fabric South Shields softeners. NE33 5SP Line dry. Do not tumble dry. (fig. 3) info@JMLgroup.co.uk 2 If there are loose threads on the Freephone 0800 781 7831 pad carefully cut the threads with scissors. Do not pull on them or cut PART PART NO. at the base. (fig.

  • Page 18: Trouble Shooting

    Trouble Shooting PROBLEM POSSIBLE REASONS & SOLUTIONS The Shark Steam ® Your steam-mop should be securely plugged into a 220-240V electrical outlet only. Lite steam mop will not turn-on. Check your fuse or breaker. Shark Steam Lite ® Is there water in the water tank? If not, add water to your steam mop will not Steam Mop following instructions on page 5. make steam. Shark Steam Lite ® Is your microfibre cleaning pad too wet? Unplug your steam mop leaves Steam Mop and change the microfibre cleaning pad.
  • Page 19 This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic equipment (WEEE). This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions. T his marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material sources. To return your used device, please use the return and collection systems or contact the retailer where this product was purchased. They can take this product for environmental safe recycling. www.sharkclean.co.uk...
  • Page 20 JML, Unit 1 Eastside Port of Tyne South Shields NE33 5SP info@JMLgroup.co.uk Freephone 0800 781 7831 www.sharkclean.co.uk Registered address: JML House, NW5 3EG Technical Details Model number: S3250UKJR 11 Input: 1550 Watts Main unit voltage: 220-240V., 50 Hz Printed in China Illustrations may differ from actual product. S3250UKJR.E.101004 Not to be disposed of with other household waste. IP44...

This manual is also suitable for:

Steam lite s3250ukjr 11

Table of Contents