Outputting A Program Source To Amplifier, Etc., In The Zone2 (Or Zone3) Room (Zone2 Or Zone3 Select Mode); Remote Control Unit Operations During Multi-Source Playback; Recording (Audio And/Or Video); About The Memory Functions - Denon DRA-700AE Operating Instructions Manual

Operation
Outputting a program source to amplifier, etc.,
in the ZONE2 (or ZONE3) room (ZONE2 or
ZONE3 SELECT mode)
1 < ZONE/REC SELECT >
Press to select "M-ZONE".
RECOUT
M-ZONE
2
FUNCTION
Use to select the source you want to
output appears on the display.
• The " " indicator and the indicator for the selected
source light.
3
Start playing the source to be output.
For operating instructions, refer to the manuals of the respective
components.
• The signals of the source selected in the ZONE mode are also
output from the VCR and CD-R/TAPE recording output terminals.
Remote control unit operations during multi-
source playback
1
[ZONE2 (ZONE3) ON]
Press to turn on the zone power.
To cancel the ZONE2 or ZONE3 mode:
Press [ZONE2 OFF] or [ZONE3 OFF].
2
[FUNCTION]
Use to select the input source you wish
to output.
• The " " indicator and the indicator for the selected
source light.
The MULTI ZONE source switches directly.
When the MULTI ZONE SOURCE function is set to "TUNER",
the preset channel can be selected pressing [PRESET].
3
The volume of the outputs of the different zones can
[VOLUME]
be adjusted with .
Default volume setting
ZONE2/ZONE3 : – – – dB (Minimum)
The zone volume can be adjusted within the range of –80 to 18
dB, in steps of 0.5 dB.
• When using ZONE2 or ZONE3, it is possible to turn the power for
the MAIN ZONE only on or off by pressing [MAIN ON/OFF].

Recording (audio and/or video)

1 < ZONE/REC SELECT >
Press
appears on the display.
M-ZONE RECOUT
2
FUNCTION
Use to select the source to be recorded
(audio and/or video).
• The " " indicator lights.
3
Record (the audio or video signals).
For operations, see the operating instructions of the device from
which you are recording (audio or video signals).
• To cancel, press < ZONE/REC SELECT > and set the function to "ZONE".
NOTE:
• When the REC OUT mode is selected, [ZONE2 (ZONE3) ON] and
FUNCTION (ZONE) cannot be operated.
24
ENGLISH

About the memory functions

¢ Last function memory
The various settings set when the DRA-700AE/700AEDAB's power is
switched to standby are stored in the memory. When the power is
turned back on, the settings made when the power was switched to
standby are recalled.
¢ Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.

Initialization of the microprocessor

If the indication on the display is not normal or if the operation of the
unit is not correct, then the microprocessor should be reset by the
until "RECOUT" following procedure.
1
Switch off the unit using
2
Keep both
on the unit by pressing
3
Check that the entire display is flashing at 1-second
intervals and release the buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from the
factory).
Operation
< POWER >
.
< SPEAKER >
A B
( and ) depressed and turn
< POWER >
.
ENGLISH