Outputting A Program Source To Amplifier, Etc., In A Different Room (Zone2 Mode); Remote Control Unit Operations During Multi-Source Playback - Denon AVR-2106 Operating Instructions Manual

ENGLISH
Advanced Operation
FUNCTION ZONE2/REC SELECT
ZONE2
POWER SPEAKER
Outputting a program source to amplifier,
etc., in a different room (ZONE2 mode)
1
ZONE2/REC SELECT
Press the
the "ZONE2 SOURCE" on the display.
The display switches as follows each time the button is
pressed.
ZONE2
2
FUNCTION
Turn the knob to select the source
you want to output appears on the display.
3
Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
To cancel, turn the FUNCTION knob and select "SOURCE".
4
ZONE2
Press the button.
• The signals of the source selected in the ZONE2 mode are also
output from the VCR-1, VCR-2 and CDR/TAPE recording output
terminals.
• Digital signals are not output to the ZONE2 output terminals.
ZONE2 OFF
FUNCTION
Remote control unit operations during
multi-source playback (selecting the source)
1
button to display
Set the
2
REC Set the
3
Press the
To cancel the ZONE2 mode:
Press the ZONE2 OFF button.
4
Press the
Lights
The ZONE2 source switches directly.
5
The output level of the ZONE2 SPEAKER OUT
terminals can be controlled pressing the
VOLUME
Default setting (ZONE2 VOLUME LEVEL):
– – – dB (MINIMUM)
ZONE2 ON
CHANNEL
MODE 1 MODE 2
VOLUME
MODE 1
switch to the "AUDIO".
MODE 2
switch to the "ZONE2".
ZONE2 ON
button.
FUNCTION
button.
button on the remote control unit.
39
ENGLISH
6 When the ZONE2 SOURCE function is set to
TUNER, the preset channel can be selected
CHANNEL
using the button on the remote
control unit.
This is only possible when the main unit in the ZONE2 mode
( page 47).
Advanced Operation