Serial Number Location - BOLIY PRO3600SI User Manual

*Clamp the wire harnesses securely so that they do not interfere with the
rotating parts, moving parts and hot parts.
*Route and connect the wire harnesses properly. Be sure that the harnesses
are not slack, twisted or pulled overly taut.
*Route the wire harnesses properly so that they do not contact sharp edges
and corners and the end of the bolts and screws on the body.
*If a wire harness must contact the end of the bolts or screws or sharp edges
and corners, protect the contact part of the harness with a loom or by winding
with electrical insulating tape. If the wire harness has a grommet, set the
grommet securely.
*Take care not to pinch the wire harnesses during installation of a part. If a
wire harness has damaged insulation, repair by winding with electrical insulating
tape.
*When using an electrical tester like a volt/ohm meter or clamp on meter, read
the manufacturer operating instructions carefully before operating the tester.
Be sure that the tester battery is fully charged and the meter is functioning
properly

2.5 Serial number location

The engine serial number is stamped at the underside of engine side cover.
Refer to this number when ordering or making technical inquiries.
One engine serial number-one machine bar serial number
Engine serial number
Machine bar serial number
xxxxxxxx
Engine serial number
Machine bar serial number
8