F E At U R E S - O P E R At I O N S; Operating Instructions - Bionaire BSF1411AR-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S

2. Press and hold the Middle Joint Pivot Button below
the control panel (press from both sides of the
button), and use another hand to pull up the fan
head to vertical position, and then release the button
to fix the position (see Figure 3).
3. NOTE: Cut and remove the zip tie from the pole
(see Figure 3). To extend the height of the stand fan,
simply pull up the fan head to draw out the
extension pole to your desired height.
4. Take out the remote control from the logo plate to
prepare for operations.
Figure 3
Extension Pole
Base Joint
Pivot Button

OPERATING INSTRUCTIONS

1. Set fan on a dry, level surface.
2. Connect the power adapter to the power jack located
above and to the side of the Base Joint (see Figure
4). Plug the power adapter into any standard 120
volt AC outlet.
3. To turn the fan on, press the power button ( )
located on the control panel or remote control.
4. To select your desired speed setting, press the speed
button ( ) on the control panel or press the arrow
buttons ( / ) on the remote control to cycle
through three speed settings (1-2-3). The
corresponding indicator light will illuminate to
indicate which setting is selected.
Remote Control
snapped on the
logo plate
Middle Joint Pivot
Button
5. To turn the oscillation on and off, press the oscillation
button ( ) located on the control panel or remote
control.
6. To set your fan to automatically shut off, press the
timer button ( ) located on the control panel or the
remote control. When set, the fan will run and
automatically shut off after the set duration of time
(1, 2, 4, or 8 hours) has expired.
Figure 4
B
C
D
F
G
I
A. Outer Ring
B. Fan Head
C. Logo Plate
D. Control Panel
E. Middle Joint Pivot
Button
F. Extension Pole
A
Remote Control
E
J
K
J
H
G. Extension Pole
Release Button
H. Base Joint Pivot
Button
I. Base
J. Power Jack
K. Power Adaptor