Safety Instructions - Bionaire BSF1411AR-CN Instruction Leaflet

P L E A S E R E A D A N D S AV E T H E S E
I M P O RTA N T S A F E T Y I N S T R U C T I O N S
When using electrical appliances, basic safety precautions
should always be taken including the following:
1. Read all instructions before using this appliance.
2. Use fan only for purposes described in the instruction
manual.
3. To protect against electrical shock do not immerse
unit, adapter or cord in water or spray with liquids
and plug the adapter directly into a 120V AC
electrical outlet.
4. Close supervision is necessary when any appliance is
used by or near children.
5. Unplug from outlet when not in use, when moving
fan from one location to another, before putting on
or taking off parts and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate in the presence of explosive and/or
flammable fumes.
8. To avoid fire hazard, NEVER place the cord under
rugs or any parts near an open flame, cooking or
other heating appliance.
9. Do not operate any appliance with a damaged cord
or adapter after the appliance malfunctions, or has
been dropped/damaged in any manner. Discard fan
or return to an authorized service facility for
examination and/or repair.
10. Do not run cord under carpeting. Do not cover cord
with throw rugs, runner, or similar coverings. Do not
route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be
tripped over.
11. The use of attachments not recommended or sold by
the appliance manufacturer may cause hazards.
12. Do not let the cord hang over the edge of a table,
counter or come in contact with hot surfaces or leave
exposed to high traffic areas.
13. Do not use outdoors.
14. To disconnect, grip adapter and pull from wall outlet.
Never yank on cord.
15. Always use on a dry, level surface.
16. Do not operate fan until fully assembled with all
parts properly in place.
17. This product is intended for household use ONLY and
not for commercial or industrial applications.
18. WARNING: To reduce the risk of electrical shock
and injury to persons, do not use in window.
19. WARNING: To reduce the risk of fire or electric
shock, do not use this fan with any solid-state speed
control device.
PLEASE READ AND SAVE
THESE IMPORTANT

SAFETY INSTRUCTIONS

PRE-OPERATING INSTRUCTIONS
Your fan comes fully assembled, simply unfold and
transform the fan to stand fan position, no tool is required.
Follow the below steps to transform the fan to stand fan
position and adjust to desirable height:
1. Press and hold the
Base Joint Pivot
Button on Base, and
use another hand to
pull up the fan head
with the extension
pole until reaching the
maximum angle, and
then release the
button to fix the
position (see Figure 1
and 2).
NOTE: The pole will
NOT stand perfectly
vertical when pulling
to the final location.
Figure 1
Base Joint Pivot Button
Figure 2
Base Joint Pivot Button