Advertisement
F E AT U R E S - O P E R AT I O N S
4. Insert the remaining Pole with the Threaded Joint
into the Hollow End of the pole connected to the Base
and twist clockwise to secure.
5. Insert the Decorative Cap through the Pole.
6. Insert the neck of Motor Housing into Hollow End of
Upper Pole and turn the neck clockwise to lock into
place.
7. Position the Rear Grill over the Motor Shaft, making
certain the 2 notches at the top and bottom of the
Rear Grill fit over the 2 prongs on the Motor housing.
Secure the Rear Grill in place with the Rear Grill
Mounting Nut. Turn mounting nut clockwise and
tighten firmly.
8. Position the Large Fan Blade, with hollowed interior
of the blade facing towards the Rear Grill, firmly onto
the Motor Shaft. Align the Motor Shaft pin with the
recessed groove in the back of the fan blade. Be sure
the shaft protrudes from the front of the blade.
Figure 1
C D E
B
A
A. Logo Plate
B. Front Grill
C. Blade Cap
D. Small Fan Blade
E. Large Fan Blade
F. Rear Grill Mounting Nut
G. Rear Grill
H. Grill Screw
I. Motor Shaft
J. Motor Housing Assembly
K. Oscillation Knob
L. Grill Mount
M. Tilt-Adjustment Knob
N. Thumb Screw
O. Upper Pole (Shorter)
P. Hollow End (Female)
F
G
I J K
H
P
R
Q. Threaded Joint
(Male)
R. Lower Pole
(Longer)
S. Decorative Cap
T. Base
U. Base Weight
V. Base Nut
9. Position the Small Fan Blade, with guide pins into the
hollowed interior of the Large Blade, and press firmly
into place. Also be sure the shaft protrudes from the
front of the blade.
10. Secure the fan blade onto the Motor Shaft by turning
the blade cap counter-clockwise and tighten firmly.
11. Center the Front Grill by aligning the Bionaire
horizontally and parallel to the floor, and then place
into the Rear Grill. Snap the front and Rear Grills
completely together. Tighten the Grill Screw at the
bottom of the Rear Grill. (NOTE: If Logo Plate is not
already assembled to Front Grill, you must attach it
by aligning the slots located on the back side of the
logo plate with the notches in the grill center. Press
firmly into place.)
12. Disassemble the rear cover from the 1Touch control
module by sliding to upside and separate it. Attach the
front of the 1Touch control module by sliding the 1 tab
into the corresponding hole on the pole (Figure 2).
13. Attach the rear of the 1Touch control module to the
front by inserting the 4 clips into the corresponding
holes and slide down to fix it.
14. For additional security, insert and tighten the Thumb
Screw into the top rear of the 1Touch control module.
L
M
OPERATING INSTRUCTIONS
N
Your fan is equipped with the technologically advanced
1Touch Thermostat. You can set the fan to run
continuously on a manual mode or set the 1Touch
O
Thermostat to your desired temperature setting. The
Q
1Touch Thermostat will automatically turn your fan ON or
OFF according to changes in the room's temperature
S
based on your preset temperature setting. The comfort
T
level ranges between 15°C and 27°C (60°F and 80°F ).
U
V
Figure 2
®
logo
Advertisement
