Table of Contents
Advertisement
PREPARING TOOL FOR OPERATION — TOOL PROBLEMS
SYMPTOM
Fasteners do not slide freely into
Magazine; strip does not advance into
nose of tool.
Follower does not engage the strip
properly; Follower snaps forward when
released, bypassing strip.
Follower carrier does not advance.
Battery Clip does not latch securely.
TRAKFAST REPAIR MANUAL
POSSIBLE PROBLEMS
Pin or pins not properly collated.
Damaged strip.
Burr(s) in Shear Block
Follower spring broken, missing or
improperly installed.
Follower defective.
Damaged Constant Force Spring
Improper assembly of Lockout
Bracket.
Battery Clip broken or distorted.
TROUBLESHOOTING GUIDE
SERVICE
Use strip with proper collation.
Discard the damaged strip
Replace Shear Block
Install new Constant Force Spring.
Replace Follower
Replace Constant Force Spring.
Check for proper assembly.
Replace Battery Clip.
Rev. 09/07
62
Advertisement
Table of Contents
