Table of Contents
Advertisement
TRAKFAST REPAIR MANUAL
TOOL REASSEMBLY
Housing Assembly - (cont'd)
Note orientation of Cage on the Sleeve.
Check Piston to see if it is bent or tip is worn.
Check Piston Rings for damage.
Clean inside the grooves.
Check to make sure Piston is not too short. If length is too short,
the tool will not shoot overhead or drive fasteners properly.
Lubricate Piston Rings and inside of Sleeve Bore with TrakFast or
Paslode Impulse oil prior to assembly.
Place Piston inside Sleeve. Always make sure Piston Ring end
gaps are opposite of each other.
Tap downward.
With large Snap Ring Pliers, place Retaining Ring into position.
Note: Do not place ends of retaining rings in the vertical notches.
52
Rev. 09/07
Advertisement
Table of Contents
