Setting The Measurement Volume Level - Lyngdorf Audio RoomPerfect RP-1 Owner's Manual

Setting the Measurement Volume Level

When setting the measurement volume level, it is important that you always judge whether the calibra-
tion volume is too loud. The calibration volume should not be so loud that it causes:
• uncomfortably loud sounds that are inconvenient to you or your environment, or
• damage to your loudspeakers.
When the message 'Connect and place mic. in focus pos.' appears, connect the microphone to the mi-
crophone input found on the back panel. Thereafter, place the microphone, using the microphone stand,
in an appropriate focus/listening position. This location should be at your main listening position, typically
more or less centered between the loudspeakers.
Make sure that the height and the orientation of the microphone corresponds to your typical listening
height and direction as illustrated and do not block the line of sight between the microphone and the
loudspeakers.
When the microphone has been correctly connected and placed in the focus position, you are ready to
set the calibration volume. The calibration signal is a combination of the high and low frequency measur-
ing signals and is only presented in your left loudspeaker. The measuring signals sound very artifi cial and
disharmonic due to the fact that they are composed of pure tones at different frequencies.
Press Enter to confi rm and to commence the calibration process.
If the RP-1 is connected before the volume control of your amplifi er e.g. when using
Option 2 or a 'tape 2' loop as described in Option 3 in the "Connecting the RP-1"
chapter, be aware that the volume control of your amplifi er is set at an appropriate
level when making the RoomPerfect calibration.
The volume control should be set at 0dB, which typically is in the "12 o´ clock" po-
sition. This setting must be used again if you wish to add additional RoomPerfect
measurements later.
The test signal will start and shortly thereafter the RP-1 will suggest an initial estimate of the desired
maximum calibration volume, displayed as 'Adjust level: XX up/down - Retry/Save Current'
Please raise or lower the volume by pressing the Up/Down buttons on the RP-1 front panel or remote
control towards the desired number of steps shown on the display but ensure you avoid clipping, uncom-
fortably loud levels and damage to the loudspeakers. Continue choosing Retry for a re-estimation of the
desired maximum calibration volume, until an appropriate calibration volume is reached. If you fi nd the
suggested calibration volume too loud simply turn down the volume to an appropriate level and choose
Save current.
19