Key Functions - Cardinal C6 Operation Manual

This section describes the use of each of the keys on the C Series Digital Counting Scale.
It will be helpful to refer to the scale keyboard or the figure below when reading this section.







  
The membrane keyboard is not to be operated with pointed objects (pencils,
pens, fingernails, etc). Damage to keyboard resulting from this practice will
NOT be covered under warranty.
SAMPLE This key is used to weigh a known number of pieces in preparation for a new
counting operation. Sample quantities are entered using the numeric keypad in
SIZE
any quantity desired.
Pressing this key will display the calculated average piece weight from the
SAMPLE
current sampling and counting operation. It will also allow the manual entry of
WEIGHT
a known average piece weight (using the numeric keys) to be used in the next
counting operation.
This key is used when setting the Quantity and Weight Preset limits. During a
COUNT
counting operation (with the limits set) if the quantity or weight exceeds the
PRESET
limits, the error beeper will sound and an error message will flash on the display.
The MC key is used to clear the accumulator. The M+ and ADD annunciators
MC will turn off to indicate the clearing has taken place.
Pressing the M+ key will cause the scale to display the contents of the
M+ accumulator (the number of pieces accumulated since the last time the
accumulator was cleared).
The M+ key is also used to add the current piece count value to the
accumulator. The M+ annunciator will be selected to indicate the accumulation
has taken place.

KEY FUNCTIONS

 
8526-M260-O1  C Series Operation
3