Table of Contents
Advertisement
Lacanche ranges are supplied with the appropriate gas fitting for the gas type specified when the
order is placed. However, the setting must be fine tuned (COMMISIONED) when the cooker is
installed.
The cooker is designed to operate with the gases in table 4, appendix 0.
IMPORTANT : Close the mains gas valve before carrying out any works.
In case of use with a gas other than that for which the cooker was initially set up, it is cru-
cial to replace the injectors and modify the adjustments as defined below.
CHANGING GAS TYPE (Changing the Jets on a Gas Cooker)
HOB :
Lift the air ring up to reveal the injector (see
►
Replace the injectors (see
►
mm).
If necessary, the mixer tubes of the lateral burners maintained by a cross-bar (see
may be released.
To release the tubes loosen screws (see
Note: Ensure that new jet is fitted with a new washer, and tighten into place.
Adjusting the primary air :
Put the burner in place and ignite it.
►
Lower the air ring to appropriate level for that gas type (see
►
(flame should be crisp, blue without any yellow).
A
B
wrench, 12
INSTALLER'S MANUAL
CHANGING GAS TYPE
IMPORTANT
A
, figure
B
1
) in accordance with table 5 in appendix 0 ( Ø in 1/100
, figure
D
, figure
1
E
3
Sully - Ft 124a - GB - Rév 06 - Modifié le : 07/10/2013
1
).
2
) and then screw (see
F
4
, figure
C
C
2
, figure
),
E
3
, figure
).
), tabel 6 in appendix 0.
D
2
F
4
13/42
Hide quick links:
Advertisement
Table of Contents
