Setup Flow - Epson TM-U220 Reference Manual

3.2 Setup Flow

You have to set up your printer to use it. And you can adjust some features by customizing
them. This section describes the setup.
The set up flow of preparing to use printer is below.
3. Connect the Printer to the host PC/POS terminal
3-4 Setup
1. Printer set up
❏ Install Ribbon Cassette
❏ Install Paper Roll
❏ Connect the Printer to the Power Supply
(See "Printer setup," (page 3-6))
(See "Install a Printer Driver in the Host PC / POS Terminal" (page 3-30))
When you select
Direct control
method (ESC/
POS command)
you don't need
to install any
drivers.
2. Adjust various settings (If you need to)
❏ DIP switches
❏ Memory switches
❏ Paper width
(Adjust the spacer & Memory switches)
❏ Roll Paper Near End Detector
(For equipped model only)
❏ Auto cutter method (Type A, B)
(See "Adjusting Various Settings" (page 3-14))
4. Driver setup
❏ OPOS
❏ APD
(See "Install a Printer Driver in the Host PC /
POS Terminal," (page 3-30))
5. Complete set up
Rev. E