Adjusting Roll Paper Width - Epson TM-U220 Reference Manual

3.4.5 Adjusting Roll paper width

The TM-U220 accommodates 76 mm {3"},69.5 mm {2.74"}, 57.5 mm {2.26"} wide paper rolls.
Note:
When you use a near-end detector equipped model, be sure not to pinch the lead wires of the near-end
detector between the roll paper guide and the roll paper holder, and to push the lead wires inside so that the
lead wire of the paper-end detector does not contact the motor gear.
When replacing the wires, be sure that the wires do not catch between the roll paper guide and the roll
paper holder.
leading the wires
between the holder
and frame
Roll paper guide
1. Make sure the power supply is disconnected.
2. Open the roll paper cover.
3. Take off the roll paper guide from the printer by loosening the two screws.
Roll paper
guide
position of fixing
the screws (left
side)
4. Push the roll paper guide on the appropriate width. (See figure above.)
3-24 Setup
A
B
C
Roll paper holder
A: paper width76 mm
B: paper width69.5mm
C:paper width57.5mm
position of fixing the
screws (right side)
Rev. E