Connectingthe Water Supply - Kenmore 253.7034 series Use & Care Manual

Connecting the Water Supply
5. With steel clamp and screw, secure Plastic Water Tubing Stee
water supply line (copper tubing only) to \ to Ice Maker_ t_/-'-'^, 1
rear panel of refrigerator as shown. \ Fill Tube /f_{ ulamp
6. Coil excess water supply line (copper \
tubing only), about 21/2 turns, behind _-- Stainless
refrigerator as shown and arrange coils _ wateSitenee I
so they do not vibrate or wear against
any other surface. _ -Water Va ve
7. Turn ON water supply at shuto_ valve __L_b_ Bracket
and tighten any connections that leak. X--Valve Inlet
Z2 2 :
8. Reconnect refrigerator to eiectdcal c,-
power source.
Plastic Water Tubing /_ Steel
to Ice Maker _ Clamp
Tube
)ression from household water
supply
Nut
waterline
Bracket
ive Inlet
water line
(Include enough tubing in loop to
allow moving refrigerator out
for cleaning)
Figure I
Figure 2
IMPORTANT
After connecting the water supply, refer to
"How to Prime the Water Supply System"
for important information about priming
an empty water supply system.
Your refrigerator's water supply system
includes several tubing lines, a water
filter, a water valve, and a water tank. To
ensure that your water dispenser works
properly, this system must be completely
filled with water when your refrigerator
is first connected to the household water
supply line.
16