Kenmore 253.7034 series Use & Care Manual page 37

Before You Call (continued)
CONCERN POTENTIAL CAUSE COMMON SOLUTION
DISPENSER (ice & Water) (continued)
Dispenser will * Dispenser lock out s • Press and hold control lock for three
not dispense engaged. I seconds.
water. • Water filter not seated " Remove and reinstall the water filter.
I properly, sure to push firmly so that
Be the filter
I I you hear it loci< solidly into position.
I " Water filter is clogged. I " Replace filter cartridge. Be sure to
I remove protective caps and push the
I filter firmly so that you hear it lock
I I solidly into position.
I " Household water l ne I " Open household water line valve. See
I valve is not open. CONCERN column AUTOMATIC ICE
I I MAKER.
Water has * Water has not been * Draw and discard 10-12 glasses of
an odd taste dispensed for an water to freshen the supply.
and/or odor. extended period of time.
• Unit not properly * Connect unit to cold water line that
connected to cold supplies water to the kitchen faucet.
water line.
Water . - Cut-off and cut-on I " Have someone turn up the cut-off and
ePressure is pressures are too low , cut-on pressure on the water pump
xtrerneiy (well systems only), system (well systems only).
low. " " Reverse osmosis system " " It is normal for a reverse osmosis
J is in regenerative " system to be below 20 psi during the
- phase. • regenerative phase.
Water not * As warmer tap water * Add ice to cup or container before
cold enough, goes through the dispensing water.
filter and enters the
water supply system
the chilled water is
pushed through to the
dispenser. Once the
chilled water is used up
it will take several hours
to bring the freshly
replaced water to a
cooler temperature.
37