Table of Contents
Advertisement
STEP 3:
PREPARE THE VENTING BLOWER
WALL-VENTED
INSTALLATION:
1. Remove one blower unit mounting screw and two
blower plate screws. Remove the blower plate
from cabinet. See Figure 12.
2. Carefully lift the blower unit out of the microwave
oven.
3. Use side cutters or tin snips to cut and remove
knockouts "B" from Back plate. Discard
knockouts. Be careful not to distort the plate. See
Figure 13.
4. Reassemble the blower wire. See Figure 14.
5. Rotate the unit so that the exhaust ports face the
rear of the cabinet. See Figure 15. When you insert
blower unit, blower wire must be like figure 15.
6. Place blower unit back into cabinet. Check that
the exhaust ports face towards the rear of the
cabinet. See Figure 16.
7. Reattach the blower plate to cabinet so the
exhaust ports and blower plate opening are
aligned. Attach with one blower unit mounting
screw and then two blower plate mounting
screws. See Figure 17.
blower unit
Knockouts "B"
blower plate
Figure 12
Parts "B"
Figure 13
--
back plate
plate
mounting screws
blower unit
mounting screw
Knockouts Parts "B"
Figure 14
Figure 15
exhaust
ports
blower
unit
mll
m
Advertisement
Table of Contents
