IBM p 655 series User Manual page 53

Please wait....
***** Power Trace Data Start *****
00000000ffffffffffff0006158800a000061574a00000060200353700060210
031300060242000000060241040b0006110a0040000611090200000611020804
0000000000061102080b0006041000000006d0e3850000061103000000061109
02000006040200000006040200010006041000010006d0e38501000604100002
000000000006d0e385020006041000030006d0e3850300061580100000061540
03180006101116000006101116010006158010010007158156a0000711000010
00000000000910120000000910120001
***** Power Trace data End *****
– Start SPCN Flash Update
This option is not available on this system.
– Display Power Subsystem FRU Code Levels
This option is not available on this system.
– Power Subsystem Code Update via the Power Control Network
This option is not available on this system.
– Start Power Subystem Code Update:
This option is not available on this system.
v LED Control Menu
This menu displays the state of the I/O subsystem disturbance/system attention LED. Use this menu to
toggle the attention/fault LEDs between identify (blinking) and off. Option 1 is only available when the
system is in the error state (the processor subsystem is powered on and the service processor menus
are available). Option 1 is not available when the system is in standby. An example of this menu
follows:
LED Control Menu
1. Set/Reset Identify LED state
2. Clear System Attention Indicator
98. Return to Previous Menu
0 >
If option 1 is selected, a list of location codes of the I/O subsystems is shown. The screen will be similar
to the following:
LED Control Manu
1. U1.9-P1
2. U1.9-P2
3. U1.5-P1
4. U1.5-P2
Enter number corresponding to the location code, or
press Return to continue, or 'x" to return to the menu.
0>4
(Press Return to Continue)
Chapter 4. Using the Service Processor
35