Quick Reference Chart - Vetta C-25 Owner's Manual

C-25 QUICK REFERENCE CHART
FUNCTION
Switch from Bike 1 to Bike 2
Start/Stop Total Time Stopwatch
Reset Stopwatches
Enter Wheel Size Programming Mode
Enter Clock Programming Mode
Adjust Digits in any Programming Mode
Set Digits in any Programming Mode
Quick Programming Escape
TEST OF INSTALLATION
Once you have finished with the installation procedure, you are ready to test the unit to make sure that it works.
STEP 1
Advance the computer to the speedometer mode.
STEP 2
Pick up the front of the bicycle and spin the front wheel. The computer should register speed within 1-2 seconds.
If you do not get a speed reading, check to be sure that the magnet and sensor alignment is correct and that
the space between the magnet and sensor is 1-2mm or less. If this does not solve the problem, call the Vetta
customer service hotline at 1.800.GO.VETTA.
KEY ACTION
A Hold for 2 Seconds
C Press
C Hold for 2 Seconds
B Hold for 2 Seconds in Trip Distance Mode (
B Hold for 2 Seconds in Clock Mode
C Press, Hold for Fast Advance
B Press
A Press at any Time when in Programming Sequence
)