Driveshaft Maintenance; Rear Axle Maintenance - Arrma Raider Maintenance Manual

Driveshaft Maintenance

Every 20 runs or so it may
be necessary to clean and re-grease the drive-
shafts as well as check for wear and/or damage.
Running in dusty, sandy or wet conditions will mean
that this will need to be performed more frequently.
1
Remove rear wheel with 7mm nut-driver/cross
wrench. Separate camber-link from balljoint with pliers.
3
Visually check driveshaft is not twisted or bent. If
necessary, replace. Re-grease driveshaft ends and refit.

Rear Axle Maintenance

Every 20 runs or so it may
be necessary to inspect the rear axle for wear. Running the
model in dusty, sandy or wet conditions will mean that this will
need to be performed more frequently.
1
Remove rear wheel with 7mm nut driver/cross wrench.
Remove rear hex hub and drive pin from axle.
Tools Required
ARRMA-RC.COM/
SUPPORT/
7mm Nut Driver or Cross Wrench
ARRMA-RC.COM/
SUPPORT/
9
Cloth
2
Remove driveshaft. Clean driveshaft ends and axle
inputs and differential out-drives.
4
Refit camber-link ball-joint with long nose
pliers and refit rear wheel with 7mm nut
driver or cross wrench.
Tools Required
7mm Nut Driver or Cross Wrench Long-nose Pliers
2
Separate camber-link from ball joint with long-nose pliers.
Grease Long-nose Pliers