Servo Removal - Arrma Raider Maintenance Manual

Steering Access (cont.)
5
Disconnect servo arm ball-joint and remove steering
assembly from servo box.

Servo Removal

Tools Required
1
Access the receiver (page 19); unplug the steering servo
wire (CH1) and remove the wire from the receiver box.
3
Remove six screws holding servo box to chassis
with 2mm hex driver and separate.
6
2mm Hex Driver
Steering
(CH1)
Throttle
(CH2)
20
Inspect servo saver, ensuring that it is set to the
factory setting above. Set with 7mm hex driver.
Reassembly is the reverse the removal process.
ARRMA-RC.COM/ Upgrading your servo will give quicker
SUPPORT/
and more powerful steering.
2
Follow the steps in 'Steering Access' section
- (page 19) and remove the front subassembly
and steering mechanism.
4
Remove four screws holding servo box halves
together with 2mm hex driver and separate.
4mm
WWW.ARRMA-RC.COM