Chassis Maintenance; Wheel And Tyre Maintenance - Arrma Raider Maintenance Manual

Chassis Maintenance

Tools Required
Cloth
AFTER RUNNING:
• Clean the car, paying special attention to the
areas on the right
• Ensure that drivetrain, suspension and
steering are clean, free and lubricated
• Check that all the screws are tight
• Check tyre/wheel condition
DO NOT RUN THE CAR IF ANY
PARTS ARE DAMAGED
Please contact your local distributor
to order replacement parts.
N.B. Raider chassis shown as an example - information applies to all variants.

Wheel and Tyre Maintenance

1
Tools Required
7mm Nut Driver
or
Cross Wrench
Tyre Glue
3
If the tyre needs re-glueing, gently pull tyre away
from the wheel rim, apply a small amount of tyre
glue, re-seat the tyre and hold until glue has set.
Automotive
Brake
Cleaner or
Brush
Nitro Car
Cleaner
N.B. Fury shown as an example - information applies to all variants.
Ensure model is switched off and drive
battery is removed; then remove wheel with
7mm nut driver or crosswrench.
4
Online videos when
you see this icon >>
2
Visually inspect the tyre sidewalls and tread
for damage or heavy wear. Replace wheel
and tyre if either is found to be worn. Check
that tyre bead is securely glued to the rim.
Refit the wheel with a 7mm nut driver or cross wrench 'finger-tight',
then tighten a further 1/4 turn. Do NOT over tighten the wheel nut or
damage to the wheel bearings may occur.
6
ARRMA-RC.COM/
SUPPORT/
ARRMA-RC.COM/
SUPPORT/
WWW.ARRMA-RC.COM