Toshiba Tecra 700CS Maintenance Manual page 45

Check 3 Using the Toshiba MS-DOS system disk, install a system program on the hard disk
using the SYS command.
If the following message appears on the display, the system program has been
transferred to the HDD.
System transferred
Restart the computer. If the error message still appears, perform Check 4.
Check 4 The HDD is connected directly to the system board. This connection can become
disconnected or damaged. Disassemble the computer as described in Chapter 4,
Replacement Procedures. If the HDD is not connected, connect it to the system
board and return to Procedure 1. If the HDD is firmly connected to the system
board, perform Procedure 3.
System Board
Procedure 3 Format Check
The computer's HDD is formatted using the low-level format program and the MS-DOS
FORMAT program. To format the HDD, start with Check 1 below and perform the other
steps as required.
Check 1 Using the Toshiba MS-DOS system disk, partition the hard disk using the FDISK
command. Format the hard disk using FORMAT C:/S/U to transfer the system
program to the HDD. If the following message appears on the display, the HDD
is formatted.
Format complete
If any other error message appears on the display, refer to the Toshiba MS-DOS
Manual for more information and perform Check 2.
Check 2 Using the Diagnostics Disk, format the HDD with a low-level format option.
Refer to Chapter 3, Tests and Diagnostics, for more information about the
diagnostic program.
If the following message appears on the display, the HDD low-level format is
complete.
Format complete
Partition and format the HDD using the MS-DOS FORMAT command. If you
cannot format the HDD using the Tests and Diagnostic program, go to Procedure
4.
700 Series
HDD
2-25