Table of Contents
Advertisement
1-1. Installation Procedure
Installation procedure of this unit is shown on the follow-
ing flowchart.
Refer to each section about detail of each flow.
The operation manual is also reqruired to do *-marked
flow.
Start
Determination of
1-3. Operating Conditions
installation place
1-4. Power Supply
Unpacking
Installation
1-5. Installation Space
*Connection
1-6. Connectors/Cables
1-7. Signal Inputs and Outputs
*Initial setup
1-8. Settings for Internal
1-9. Setup Extended Menu
1-10. Settings for External Editors
*Operation check
End
1-2. Supplied Accessories
Cap, BNC ........................................................................ 11
Cap, DC OUT .................................................................... 2
Cap, XLR (F) ..................................................................... 2
Cap, XLR (M) ................................................................... 5
Cap, DUST ........................................................................ 1
Shoulder belt assembly ...................................................... 1
Rear panel cover ................................................................ 1
Operation manual .............................................................. 1
Installation manual ............................................................ 1
n
After installation, be sure to use the supplied caps for
protecting unused connectors.
DNW-A25WS/A25WSP
Section 1
Installation
Switches/Slit Lands
1-3. Operating Conditions
c
Do not block an air vent. If ventilation is not enough, the
unit may be damaged due to increase the internal tempera-
ture of the unit.
. Do not shove the unit into cramped place with poor
ventilation.
. Be sure to make cleaning if a cooling fan is covered with
dust.
. Replace a cooling fan periodically.
. Do not place the unit on a longhaired carpet.
. Do not cover the unit with cloth.
n
Good air circulaiton is essential to prevent internal heat
build-up. Place the unit in location with sufficient air
circulation.
Do not block the ventilation holes of the cabinet and the
front and rear panels.
Operating temperature: 0dC to 40dC
Operating humidity:
25% to 80% (Condensation not
allowed)
Storage temperature:
_20dC to 60dC
Locations to avoid:
. Areas where the unit will be exposed to direct sunlight
of any other strong lights.
. Areas near heat sources.
. Dusty areas or areas subject to vibration.
. Areas with strong magnetic field.
. Areas with much electrical noise.
. Areas with much static electricity.
. Areas that is impossible to find a specified room for
installation.
(Refer to Section "1-5. Installation Space" .)
. Areas windtight.
1-1
Advertisement
Table of Contents
