Panasonic KX-TC1871CB Operating Instructions Manual page 89

Problem
The unit does not display the
caller's name and/or phone
number.
The handset display goes to
the standby mode while
viewing the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller's
name and/or phone number.
(LOCATOR/INTERCOM)
not function.
You cannot redial by
(REDIAL/PAUSE)
pressing
(REDIAL)
.
You cannot have a
conversation using the
handset.
You cannot have a
conversation using the
headset.
Cause and Remedy
≥You do not subscribe to a Call Display
service.
≥Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
≥Other electrical appliances connected to
the same outlet may be interfering with
the Call Display information.
≥Telephone line noise may be affecting
the Call Display information.
≥Do not pause for over 60 seconds while
searching.
(DIGITAL\SP-PHONE)
≥
≥The line mode selection is incorrect.
See page 19.
does ≥The handset is too far from the base
unit.
≥The handset is engaged in an outside
call or is viewing the Caller List/directory
list. Wait until the IN USE/CHARGE
indicator light goes out.
≥If the last number dialed was more than
or 32 digits long, the number will not be
redialed correctly.
≥Access numbers entered after pressing
(TONE)
will not be included when
redialing.
≥When the optional headset is connected
(p. 86), you must use the headset to
talk with the caller. To have a normal
cordless phone conversation,
disconnect the headset.
≥Make sure that the optional headset is
connected properly (p. 86).
"
was pressed.
89