Table of Contents
Advertisement
Sound Detection
Interval Time To
Detect
Upload Event File to
FTP
Send Event File to
Email
Video Recording
Time
Save Event Files to
NAS or SD
Video Recording
Time
Sound Level
Enable or disable the sound detection
function of your network camera.
After sound is detected, the network camera
will not detect sound again for this length of
time. For example, using an "Interval Time To
Detect" of 20 seconds means that after sound
is detected, the camera will not detect any
further sound for 20 seconds. Then after 20
seconds, the camera will detect sound again.
A video recording of a detected event can be
sent to a designated FTP server. Select
"Enable" or "Disable" for this function. When
enabled, you need to configure the FTP server
information on the "FTP" page of the "Events
Notification" menu.
A video recording of a detected event can be
sent to a designated email recipient. Select
"Enable" or "Disable" for this function. When
enabled, you need to configure the SMTP
server information on the "SMTP" page of the
"Events Notification" menu.
Specify the length of time for the email or FTP
video recording here.
Enable or disable the camera's function to
save video files to NAS or MicroSD card.
When enabled, you need to configure the
settings in the "Storage Settings" menu.
Specify the length of time for the NAS or
microSD video recording here.
Set the level of sound which will trigger a
detection event. Adjust the slider up/down to
your preferred sound level. The vertical
display to the left of the slider indicates the
current sound level picked up by the camera's
built-in microphone.
69
Advertisement
Table of Contents
