Navigate To A Waypoint - Lowrance GlobalMap 3300C Installation And Operation Instructions Manual

4. Press ↓ to
change the first character, then press → to the next character and repeat
until the longitude is correct. Press
previous page display. The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map and in the waypoint list.

Navigate To a Waypoint

You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command (we'll describe how later in
this section.) However, you can avoid scrolling the map to pick your
waypoint if you use the Find Waypoint commands:
1. Press |↑ to
WPT
press ↓ to
N
EAREST
tire waypoint list), press
2. If your waypoint list is a long one, you can spell out the waypoint name
in the
F B
IND Y
character, then press → to move the cursor to the next character and re-
peat until the name is correct, then press
3. If the list is short, you can jump directly to the
. Use ↑ or ↓ to select the waypoint name, press
pressing
ENT
waypoint information screen appears with the
4. To begin navigating to the waypoint, press
Course line
(red)
Off course
range, set at
0.15 mile
Navigation Page, navigating toward waypoint 001 and leaving a trail.
|
L ENT
ONGITUDE
M W
Y AYPOINTS
| ; or, to look by name (and scroll through the en-
ENT
ENT
box to search for it. (Press ↑ or ↓ to change the first
N
AME
. Enter the longitude by pressing ↑ or ↓ to
, then
ENT
| . To look up the nearest waypoint,
ENT
. For this example, look by name.
ENT
47
| to return to the
EXIT EXIT
to jump to the list below.)
F I
IND
command selected.
G T
O O
.
ENT
Waypoint
Trail line
(magenta)
Destination
name
box by
L
N IST
and the
ENT