Navigate To A Waypoint; Navigate A Trail - Lowrance iFINDER PhD Operation Instructions Manual

Navigate to a Waypoint

You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command. However, you can avoid
scrolling the map to pick your waypoint if you use the Find commands:
1. Press |
FIND
look by name (and scroll through the entire waypoint list), press ↓|
For this example, look by name.
2. If your waypoint list is a long one, you can spell out the waypoint name
in the
F B
IND Y
character, then press → to move the cursor to the next character and re-
peat until the name is correct, then press
3. If the list is short, you can jump directly to the
. Use ↑ or ↓ to select the waypoint name, press
pressing
ENT
waypoint information screen appears with the
4. To begin navigating to the waypoint, press

Navigate a Trail

1. Press
MENU
one below appears.
2. Press ↓ then use ↓ or ↑ to select a trail to navigate.
3. With the trail name highlighted, press
4. Wait while iFINDER creates a route from the trail. When the prog-
ress message disappears, the unit displays a trail information screen,
with the
N
AVIGATE
. To look up the nearest waypoint, press
ENT
box to search for it. (Press ↑ or ↓ to change the first
N
AME
| |↓ to
MENU
command highlighted in the top command box.
ENT
|
M T ENT
Y RAILS
Trails Menu.
ENT
46
to jump to the list below.)
F
IND
command selected.
G T
O O
.
ENT
and a screen similar to the
|↓ to
N
AVIGATE
, or to
ENT
.
ENT
box by
I L
N IST
and the
ENT
| .
ENT