Reminder Message On/Off; Ignoring Short Stitches; Setting The Trim Tail Length; Setting The Thread Breakage Sensor - Janome MB-4S Instruction Book

08 ON
09
OFF
10 M
11 8
[08]

Reminder message ON/OFF

When you press the START/STOP button, a reminder
message will appear on the LCD screen. However, you
can turn off the reminder.
Press the right arrow button to indicate [OFF] to turn
off the reminder.
Press the ENTER button to register the new setting or
press the upward arrow button
setting.
[09]

Ignoring short stitches

Very short stitches may cause the thread to break.
To avoid this problem, turn on the ignoring short
stitches function.
Press the right or left arrow button
stitch length to be ignored or select [OFF] to turn off
the function.
Press the ENTER button to register the new setting
or press the upward arrow button
setting.
[10]

Setting the trim tail length

Some times you need to adjust the tail length of the
thread being trimmed depending on the thickness and
type of the thread.
Press the right or left arrow button
trim length.
You can select one of the following options.
S: Short
M: Medium
L: Long
Press the ENTER button to register the new setting
or press the upward arrow button
setting.
[11]

Setting the thread breakage sensor

You can adjust the sensitivity of the thread breakage
sensor by setting stitch count to judge thread breakage.
Press the right or left arrow button
sensitivity. The adjustable range is from 3 to 16.
The higher the number, the lower the sensitivity.
Reduce the sensitivity to avoid false thread breakage
due to short stitches.
Press the ENTER button to register the new setting
or press the upward arrow button
setting.
61
to go to the next
to set a
to go to the next
to adjust the
to go to the next
to adjust the
to go to the next