Optional Extras - Potterton PROFILE LPG 100e Installation And Servicing Instructions

IMPORTANT This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Installation
and Use) Regulations 1994.
Profile LPG boilers have been designed to comply with the requirements of BS5258 Part 1 and BS6332 Part 1. It is
important that no external control devices (e.g. flue dampers, economisers, etc.) be directly connected to these appliances
unless covered by these installation instructions or otherwise recommended in writing. Any direct connection of a control
device not approved by Potterton could invalidate the normal warranty.
LIST OF CONTENTS - Page 2
General

Optional Extras

Accessories
Installation Data
Boiler Dimensions
GENERAL - Page 2
This Potterton Profile 100e LPG boiler is a fully automatically
controlled wall mounted fan powered balanced flue
appliance, using a cast iron heat exchanger and has an
output rating of 29.3 kW (100,000 Btu/h).
The boiler which is designed to provide domestic hot water
and/or central heating must be used on INDIRECT hot water
systems only. The cast iron heat exchanger is suitable for
use on open vented gravity domestic hot water/pumped
central heating systems or fully pumped systems which may
be sealed are open vented.
OPTIONAL EXTRAS - Page 2
The following are kits available as optional extras:-
Internal fltment kit, Part No. 225184, which is suitable for a
maximum wall thickness of 510mm (20in.) is to be used
where access to the outside wall is impracticable.
Pump Cover Kits located on top of the boiler and designed
to conceal the pump, and/or any motorised valves installed
above the boiler (Note: Pump cannot be fitted above the
boiler if the vertical flue kit is used. The following sizes are
available:-
6 in Part No.
7in -l2in Part No.
l3in-l8in Part No.
l9in-24in Part No.
Supplied By www.heating spares.co Tel. 0161 620 6677
Page No. 2
Page No. 2
Page No. 3
Page No. 3
Page No. 3
225418
225419
225420
225421
GAD (90/396/EEC)
Site Requirements
Technical Data
Installation Instructions
Commissioning
Health and Safety Information
Control Systems, Pipework and
Wiring Guide
User's Instructions
The boiler can be supplied with either of the following types
of flue system, these are packaged with the terminal and
associated flue components.
1) Standard Horizontal flue system Part No. 225542
Suitable for a wall thickness from 100 mm (4 in.) to
510mm (20in.).
2) 1 metre horizontal flue system Part No. 225545 which
provides a maximum flue length of 955mm (37 in.).
3) 1 metre vertical flue system Part No. 213050 Which
allows the flue to pass through a flat roof and terminate
at a maximum height of 980mm (38 in.) measured from
the top of the boiler case.
Terminal Wall Plate, Part No. 212280, where necessary can
be fitted to the outside wall face to improve the appearance,
after making good around the terminal.
Terminal Guard, Part No. 205792, to be used when the
terminal is fitted less than 2m above a balcony, above
ground or above a flat roof to which people have access.
Page No.3
Page No.6
Page No 11
Page No 18
Back Page
Supplied in
Literature Pack
Publication No. 559876/0296