Table of Contents
Advertisement
Optional Equipment
Installation
WARNING:
Make sure power to the stove has been shut off prior to installation.
NOTE:
Refer to the wiring diagram on page 46 while making wiring harness connections.
1
Loosen the bottom panel attachment screws (there are two on each side see Figure 1). Slide the
bottom panel back and place it below the stove (see Figure 2). This allows for access to the controls
under the stove
2
Remove the four screws holding the control panel to the front of the stove (see Figure 3). Carefully
remove the control panel, making sure you do not disconnect any wiring (see Figure 4).
© Travis Industries
(for qualified installers only)
Figure 1
Figure 3
4090717
47
Figure 2
Figure 4
100-01225_000
Hide quick links:
Advertisement
Table of Contents
