Table of Contents
Advertisement
Operating additional equipment
Devices to the PC IN connection
You can connect a PC to the PC IN socket for example
and thus use the TV screen as a monitor.
➠ When connecting a PC or accessory equipment to the PC IN socket
of the TV set, set one of the following screen resolutions on the PC /
accessory equipment first.
800 x 600
60 Hz
(SVGA)
1280 x 1024 60 Hz
(SXGA)
720 x 576i
(SDTV)
720 x 576p
(SDTV)
1280 x 720p
(HDTV)
Connecting the device
➠ There is no need to register the device with the connec-
tion wizard.
Switch off all equipment before connecting.
Connect the device to the TV set's PC IN socket with a VGA
cable.
Connect the analogue audio signal of the PC to the AUDIO
IN2 jack on the TV set with a stereo cable.
Connection
example of a
PC
PC
Alternatively, connect the digital audio output of the PC or
accessory equipment to the AUDIO DIGITAL IN socket of
the TV set with a cinch cable.
The digital audio input can be assigned to the PC IN socket
by TV menu → Connections → Miscellaneous → Assign
digital audio input, see page 53.
1024 x 768 60 Hz (XGA)
1360 x 768 60 Hz (WXGA)
720 x 480i
(SDTV)
720 x 480p
(SDTV)
1920 x 1080i
(HDTV)
TV set
PC IN
AUDIO IN2
Playback from the device
Call AV selection.
AV selection
COMP. IN
HDMI2/DVI
HDMI1/DVI
PC IN
AVS
DVD-REC
DVD
VIDEO
Switch to ...
OK
6 S elect PC IN socket,
OK switch over.
Adapt geometry (only possible with certain signals)
This can be used to position the picture correctly and move the position
of the picture (horizontally and vertically) so that it fills out the whole
screen.
Call TV menu.
3 4 S elect Geometry,
6 go to the menu line below.
3 4 S elect the desired setting,
6 go to the menu line below.
3 4Make settings.
Set colour standard (only possible with certain signals)
Call TV menu.
3 4 S elect Picture,
6 go to the menu line below.
34 S elect and set Colour standard:
RGB or
Ycc / Ypp
The colours will not be shown correctly if the wrong
standard is set.
OK
END
45 -
Hide quick links:
Advertisement
Table of Contents
