Loewe R 37 Full-HD+ 100, R 37 HD+ 100 Operating Instructions Manual page 43

Operating additional equipment
Connecting a DVD recorder to the TV set
➠ DVD recorder is registered with the connection wizard.
Switch off all equipment before connecting.
Connect the Euro-AV output of the DVD recorder to the
AV2 socket of the TV set.
Use a fully equipped Euro-AV cable (available from your
dealer) for this.
If you want to receive and record analogue stations with
the receiver (tuner) built into the recorder, the recorder
must be looped into the aerial cable. Connect the DVD
recorder as shown in the connection example below.
Connection
example of a
DVD recorder
ANT2
➠ If you want to record DVB stations with an external
recorder, the internal receiver of the TV set must be
used (see "Timer recording with external devices" on
page 55).
Playback from AV device
Call AV selection.
AV selection
COMP. IN
HDMI2/DVI
HDMI1/DVI
PC IN
AVS
DVD-REC
DVD
VIDEO
Switch to ...
OK
 6 S elect DVD-REC,
OK switch over.
Start playback on the connected device.
AV2
S-VIDEO OUT
DVD recorder
TV
R
OK
Connecting Camcorder/camera
➠ Camcorder/camera is registered with the connection
wizard.
Switch off all equipment before connecting.
Connect the AV output of the camcorder to the audio
input sockets L/R (white/red) and the S-VHS connection
of the AVS sockets of the TV set.
Use the AV cable enclosed with the camcorder for this.
Some camcorders only supply an FBAS signal instead of
an S-VHS signal at the AV output. In this case use the AVS
video input (yellow).
TV set
Connection
example of a
camcorder
Playback from AV device
Call AV selection.
 6 S elect CAM,
OK switch over.
Start playback on the connected device.
END
S-VHS connection
Camcorder
AV selection
COMP. IN
HDMI2/DVI
HDMI1/DVI
PC IN
CAM
OK
DVD-REC
DVD
VIDEO
Switch to ...
OK
(AVS)
Audio in
L/R (AVS)
TV set
END
43 -