Firebrick Replacement - Quadra-Fire Millennium 31M-ACC-MBK Owner's Manual

R
9. Replace the door on the appliance.
Quadra-Fire stoves are equipped with ceramic super heat-
resistant glass, which can only be broken by impact or
misuse. Do not slam stove door or impact the glass. When
closing door, make sure that logs do not protrude against the
glass. Inspect glass regularly. If you fi nd a crack or break,
immediately put the fi re out and return the door to your dealer
for replacement of glass before further use.
WARNING
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
Glass
Assembly
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
& door assembly removed.
• Do NOT operate with glass cracked, broken or scratched.
WARNING
Fire Risk.
Injury Risk.
• Use only glass specifi ed in manual.
• DO NOT REPLACE with any other material.
Glass breakage will occur.
D. Firebrick Replacement
Replace the fi rebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) gap between the bricks.
Inspect the fi rebrick after each ash removal.
The fi rebox is lined with high quality fi rebrick, which has
exceptional insulating properties. There is no need to use a
grate; simply build a fi re on the fi rebox fl oor. Do not operate
appliance without fi rebrick.
1. After the coals have completely cooled, remove all old
brick and ash from unit and vacuum fi rebox.
2. Remove new brick set from box and lay out to diagram
shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of fi rebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of fi rebox and push the bottom of the brick until it is fl ush
with the side of the appliance.
August 3, 2015
10.1
10.1
10.1
10.2 10.2 10.2 10.2
1-1/4"
10.3
2"
Figure 35.1 - 3100 Millennium Brick Assembly
No.
10.1 9 x 4-1/2 x 1-1/4
10.2 6 x 4-1/2
10.3 9 x 4-1/2 with angle (see drawing)
10.4 9 x 3 with angle (see drawing)
y
4.1
4.1
4.1
4.5
1-1/4"
2"
Figure 35.2 - 3100 Step Top Brick Assembly
No.
4.1 9 x 4-1/2 x 1-1/4
4.2 6 x 4-1/2
4.3 9 x 4-1/2 with angle (see drawing)
4.4 4-1/2 x 4-1/2 x 1-1/4
4.5 9 x 3 with angle (see drawing)
Use Part 832-0550 when ordering individual brick. Provide brick
dimension or copy this page, mark the desired brick and take it to
your authorized dealer.
NOTE: The Ash Removal System is available
for the Step Top Model only and not for the
Millennium Model.
7033-277N
3100 Wood Stove Series (ACC)
10.1
10.1
10.1 10.1
10.1 10.1
10.1
10.3
9"
8"
1-1/4"
1-1/4"
10.4
2"
5"
9"
Brick Size
4.1
4.1
4.1
4.1
No brick,
4.4
4.4
Grate Location
4.2 4.2
4.2 4.2
9"
8"
1-1/4"
4.3
1-1/4"
4.5
2"
5"
9"
Brick Size
10.1
10.1
3"
Qty
12
4
1
1
4.1
4.1
4.1
4.3
3"
Qty
10
4
1
2
1
Page 35