Table of Contents
Advertisement
Explorer I
5
Service Part Replacement
A. Glass Replacement
1.
Ensure that the fi re is out and the appliance is cool to the
touch.
2.
Protect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3.
Remove the door with the broken glass by lifting the door
up and off of the hinges.
4.
Lay door face down on a table or counter making sure the
handle hangs over the edge so the door lays fl at, on a soft
surface.
5.
Remove the screws from each glass retainer and remove
the glass. (If screws are diffi cult to remove, soak with
penetrating oil fi rst).
6.
Center the glass with edges evenly overlapping the open-
ing in the door, (i.e. same space top and bottom, left and
right sides).
7.
Replace the glass retainers. Be careful not to cross thread
the screws.
8.
Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately, a
few turns at a time, until the glass is secure. DO NOT
OVERTIGHTEN.
9.
Replace the door on the appliance.
Quadra-Fire appliances are equipped with ceramic super
heat-resistant glass, which can only be broken by impact
or misuse. Do not slam appliance door or impact the glass.
When closing door, make sure that logs do not protrude
against the glass. Inspect glass regularly. If you fi nd a crack
or break, immediately put the fi re out and return the door to
your dealer for replacement of glass before further use.
CAUTION
Handle glass assembly with care.
When cleaning glass:
Glass
Assembly
• Avoid striking, scratching or
• Do NOT clean glass when hot.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white fi lm.
• Use commercial oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will permanently stain
glass on next fi ring. Refer to maintenance instructions.
WARNING
Injury Risk.
• Use only glass specifi ed in manual.
• DO NOT REPLACE with any other material.
18
slamming glass.
B. Firebrick Replacement
Replace the fi rebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) gap between the bricks.
Inspect the fi rebrick after each ash removal.
The fi rebox is lined with high quality fi rebrick, which has
exceptional insulating properties. There is no need to use a
grate; simply build a fi re on the fi rebox fl oor. Do not operate
appliance without fi rebrick.
1. After the coals have completely cooled, remove all old
brick and ash from appliance and vacuum fi rebox.
2. Remove new brick set from box and lay out to diagram
shown.
3. Lay bottom bricks in appliance.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of fi rebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of fi rebox and push the bottom of the brick until it is fl ush
with the side of the appliance.
7062-196B
February 25, 2016
Advertisement
Table of Contents
