Advertisement
Step 8
® Parts Needed For ®
Wall Panels
0 8995 Wan Panel (8)
L]N21
Each wall panel has a crimped rib on
one side. The crimped
rib should go
[Z]
under the rib of the panel that follows
it.
1 Locate all of the wall panels
and
set each one alongside
the building.
2 Be surethatyou
have the correct
panels
in each position.
Do this by
overlapping
the panels
and deter-
mining
if the holes line up with the
holes in the frame.
8995
8995
8995
Panels rest on
frame as shown
Crimped Rib
Underneath
3 Fasten the wall panels at the top
and bottom with screws.
Detail Showing
Center of Panel
Screwed to
Wall Channel
4 Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping
ribs using a bolt and nut
with two screws.
Bolt and nut
does not go thru
wall channel
at overlap
5 When you have attached
all wall
panels
in the correct
positions,
the
building
will look like this.
Use bolts and
nuts thru wall
angle overlap
at the top of
panel at rear.
21
Advertisement
