Advertisement
Installation of the washer
Remove package
Remove package and take out the bottom board of
the cabinet on the foam cover.
Open the lid of washer's door and take out accessories.
A trial operation or washing on the foamed cushion is
strictly forbidden.
Installation of drain hose
Placement of water drain hose
Under3m
If the water drain hose shall
The placed height of water
be extended, its length shall
drain hose shall not exceed
not exceed 3 meters,
15cm.
otherwise it will affect the
water discharging time.
FOR LOWER DRAIN SYSTEM ONLY
Placement of upper water drain hose
The height of drain hose ("a")should between 86-100 cm.
Diameter of "b"shuld not less than 3 cm, and flow capacity
not less than 40 L/Min.
Before washing machine starts, user should hang up the
drain pipe 86-100cm height from the floor.
FOR UPPER DRAIN SYSTEM ONLY
Installation of water inlet pipe
Put the water inlet pipe(which has
metallic filtering bag) screw on to the tap.
Tightly screw another end of water
inlet hose on water inlet valve .
(with rubber seal ring inside).
Note: When tightening the
clamping nut, evenly apply the
force and do not twist the water
inlet valve to avoid breaking of
water inlet valve joint.
Base foamed cushion
Completely sleeve the drain
hose over the sewer.
Fix and tighten it with a hoop.
( As shown in the figure )
Under 15cm
Do not bend the water
drain hose and place
it under the washer.
86~100 cm
Clamping nut
Water inlet hose
Only for model with double
screw thread water inlet pipe
5 5
Installation of the washer
Installation of water inlet pipe
2
1
Small ball
Push down the slide jacket
to expose the small balls and
enable separation of connector
socket from speedy connector.
4
A
not flat) and push it upward with force making the rubber
washer firmly press the plane center of water tap mouth.
5mm
Junk ring
B
Then tighten the screw sequentially. After that, tightly
screw on part B.
The connection socket
Connect: Push down the slide jacket
consists of A and B two
of speedy connector (4 small balls
parts. Before installation,
must be exposed ),insert it into the
A and B two parts must
connection socket and then push
be unscrewed about
upward Release the connection
5mm, or directly
of water tap with speedy connector
disconnected. If the
completely. If it is required to feed
6
bore of water tap is
water, simply open the water tap.
larger, remove the
Separate: Close the water tap, push
Connect
plastic junk ring of
down the slide jacket of speedy
part A.
connector and pull out the speedy connector.
Tightly screw another end of water inlet
hose on water inlet valve . (with rubber
seal ring inside).
Note: When tightening the clamping nut,
evenly apply the force and do not twist
the water inlet valve to avoid breaking of
water inlet valve joint.
Only for model with single screw thread water inlet pipe
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard. The instructions for appliances
connected to the water mains by detachable hose-sets shall
state that the new hose-sets supplied with the appliance are
to be used and that old hose-sets should not be reused.The
openings must not be obstructed by a carpet.This appliance
is for indoor use only.
3
Unscrew four screws of part A
and sleeve part A horizontally
5
over the mouth at the end of
water tap (the mouth at the end
of water tap must be flat and
smooth. Flatten it by filing if it is
7
Separate
Water inlet hose
Clamping nut
6
6 6 6
Hide quick links:
Advertisement
