Installation Of The Washer - Midea MFW-V1100DDi Owner's Manual

Installation of the washer

Remove package
! Remove package and take out the bottom board of
the cabinet on the foam cover.
! Open the lid of washer's door and take out accessories.
! A trial operation or washing on the foamed cushion is
strictly forbidden.
Installing the Anti-Rat Cover
1 Lay down the washing machine on a
soft fabrics or cushion.
2 Insert the anti-rat cover to be firmly
fixed from the back or front of washing
machine and screw it.
Installation of water inlet hose
Put the water inlet pipe(which has
metallic filtering bag) screw on to the tap.
Tightly screw another end of water
inlet hose on water inlet valve .
(with rubber seal ring inside).
Note: When tightening the
clamping nut, evenly apply the
force and do not twist the water
inlet valve to avoid breaking of
water inlet valve joint.
Installation of water inlet hose
Water inlet adapter
The water inlet consists
of connection socket and
speedy connector.
Base foamed cushi o n
FRONT
Soft fabrics
Clamping nut
Water inlet hose
Connector socket
Fastening screw
Lock nut
Speedy connector
Slide jacket
5
Installation of the washer
Installation of water inlet pipe
2
1
Small ball
Push down the slide jacket
to expose the small ball and
enable separation of connector
socket from speedy connector.
4
A
5mm Junk ring
B
Connect: Push down the slide jacket of
The connection socket
consists of A and B two
parts. Before installation,
A and B two parts must
be unscrewed to about
5mm, or directly
disconnected. If the
6
bore of water tap is
larger, remove the
Connect
plastic junk ring of
Separate: Close the water tap, push down
part A.
Tightly screw another end of water inlet hose on
water inlet valve . (with rubber seal ring inside).
Note: When tightening the clamping nut, evenly apply the
force and do not twist the water inlet valve to avoid breaking
of water inlet valve joint.
3
Unscrew four screws of part
A and sleeve part A horizontally
5
over the mouth at the end of
water tap (the mouth at the end
of water tap must be flat and
smooth. Flatten it by filing if it is
not flat) and push it upward with
force making the rubber washer
firmly press the plane center of
water tap mouth. Then tighten
the screw sequentially.
After that, tightly screw on part B.
speedy connector ( 4 small
balls must be exposed ),
insert it into the connection
socket and then push upward
Release the connection of
water tap with speedy
connector is completed. If it
is required to feed water,
Separate
simply open the water tap.
the slide jacket of speedy
connector and pull out the
speedy connector.
Water inlet hose
Clamping nut
6
7