Installation Of The Washer - Midea MFW-801S Owner's Manual

Installation of the washer

Remove package
! Remove package and take out the bottom board of
the cabinet on the foam cover.
! Open the lid of washer's door and take out accessories.
! A trial operation or washing on the foamed cushion is
strictly forbidden.
Installation of drain hose
Installation of water inlet hose
Water inlet adapter
The water inlet consists
of connection socket and
speedy connector.
Base foamed cushi o n
! Completely sleeve the drain
hose over the sewer.
! Fix and tighten it with a hoop.
( As shown in the figure )
Connector socket
Fastening screw
Lock nut
Speedy connector
Slide jacket
5
Installation of the washer
Installation of water inlet pipe
2
1
Small ball
Push down the slide jacket
to expose the small balls and
enable separation of connector
socket from speedy connector.
4
A
5mm Junk ring
B
The connection socket Connect: Push down the slide jacket of
consists of A and B two
parts. Before installation,
A and B two parts must
be unscrewed about
5mm, or directly
disconnected. If the
6
bore of water tap is
larger, remove the
Connect
plastic junk ring of Separate: Close the water tap, push down the
part A.
Tightly screw another end of water inlet
hose on water inlet valve . (with rubber
seal ring inside).
Note: When tightening the clamping nut,
evenly apply the force and do not twist
the water inlet valve to avoid breaking of
water inlet valve joint.
Only for model with single screw thread water inlet pipe
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
The instructions for appliances connected to the water mains by detachable hose-
sets shall state that the new hose-sets supplied with the appliance are to be used
and that old hose-sets should not be reused.
3
Unscrew four screws of part
A and sleeve part A horizontally
5
over the mouth at the end of
water tap (the mouth at the end
of water tap must be flat and
smooth. Flatten it by filing if it is
not flat) and push it upward with
force making the rubber washer
firmly press the plane center of
water tap mouth. Then tighten
the screw sequentially.
After that, tightly screw on part B.
speedy connector ( 4 small
balls must be exposed ),
insert it into the connection
socket and then push upward
Release the connection of
water tap with speedy connector
completely.If it is required to feed
water, simply open the water tap. Separate
slide jacket of speedy connector
and pull out the speedy connector.
Water inlet hose
Clamping nut
6 6
7