Identify Usual Trouble Of Washer - Midea MFW-1250MV2 Owner's Manual

Identify usual trouble of washer

When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine without
permission.
If the washer can not work normally, or appear abnormity or alarms, please check and
correct as follows.
List of faults and inspection
Faults
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
No water
If the coil of inlet valve is damaged. (The slight electromagnetic
flows in
sound is normal phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power
switch is pressed.
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.
No
(The washer will not work if the water amount does not reach the
washing
required water level)
If it is set to "Delay" washing mode. (It will only start to work
until the reservation time reached)
If the water drain hose is placed very high.
Abnormal
If the end of water drain hose is sealed in pond.
draining
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is closed.
If all clothing piled largely at one side of barrel or the clothing
Abnormal is excessively placed.
spin If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
If the motor belt is loosened.
Note: During the de spin process, if washing are piled at one side of the spin barrel,
it will cause unbalance of spin barrel resulting in striking. At this moment, the
computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can not
resolve the problem. Then the user has to manually and evenly place the clothing
inside the barrel to solve the problem.
Inspection Items
17
Malfunction display and solutions
When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine
without permission.
If the washer can not work normally, and the abnormal indication is shown in the nixie
tube window or the machine alarms, please check and correct them as follows.
Open the lid after starting
the delay time.Open the
lid when the washer is
spinning.
Alarm for water drain time out.
Technical specifications
Overall
dimensions
(mm)
Input power
600W
of motor
240V~/50Hz
Rated power
supply
After treatment
failure, switch
power key again.
45kg
Net weight
Rated capacity
of wash and
12.0kg
spinning
Application
0.1Mpa~0.6Mpa
water pressure
18