Nmf-1008 Led Keypad; Lcd5500Z Keypad; Pc5508Z Led Keypad - DSC Classic PC1555 Instruction Manual

NMF-1008 LED Keypad

System Light (NMF-1008Only):
If the Service Required light is ON, one or more of
these conditions could be present on the system:
System Busy
System Troubles (See "Viewing Trouble Conditions"
on page 10).
Zone Bypassed (See "Zone Bypassing" on page 10).
Programming The Service Required light will flash
when you are programming access codes, or
performing other programming functions. If
someone is programming at another keypad, the
Service Required light will turn ON to indicate that
the system is busy.
Display Lights (All Keypads)
Ready Light
If the Ready light is ON, the system is ready for arming.
The system cannot be armed unless the Ready light is
ON (see "Arming the System" on page 3).
Armed Light
If the Armed light is ON, the system has been
armed successfully.
Trouble or System Light
If the Trouble light is ON, see "Viewing Trouble
Conditions" on page 11.
8
Emergency Keys (All Keypads)
PC5508Z / LCD5500Z:
Press both * Keys for two seconds to send a
FIRE transmission.
Press both * Keys for two seconds to send an
AUXILIARY transmission.
Press both * Keys for two seconds to send a
PANIC transmission.
NMF-1008:
Press the [*] and [#] keys simultaneously for
two seconds to send a PANIC transmission.
* IMPORTANT NOTE (All Keypads): The Fire,
Auxiliary and Panic keys will NOT function
unless programmed by the installer. If these
keys are in service and the installer has
enabled audible feedback, holding down the
key for two seconds will cause the keypad
sounder to beep indicating that the input has
been accepted and transmission is underway.
NOTE: In the U.S.A. the [A] and keys are
programmed to be used for non-medical
emergencies only, as per UL requirements.
Display Lights (PC5508Z)
Memory Light
Upon disarming, if an alarm has occurred while
the system was armed, the Memory light will turn
ON (See "Disarming the System" on page 6).
Bypass Light
If the Bypass light is ON, one or more zones are
bypassed (See "Zone Bypassing" on page 10).
Fire Light
If the Fire light is ON, a fire alarm has occurred
(See "Fire Alarm Operation" on page 14).
Program Light
The Program light will flash when you are
programming access codes, or performing other
programming functions. If someone is
programming at another keypad, the Program light
will turn ON to indicate that the system is busy.

LCD5500Z Keypad

The Liquid Crystal Display (LCD) displays
prompts and system information on two 16
character lines.
If "< >" appears, more information can be
accessed by using the arrow (< >) keys. Press
[<] to see the previous function or item of
information. Press [>] to advance the display to
next function or item of information.
Press the keys on the number pad as prompted
by the LCD display to view alarms or troubles, to
arm and disarm the system and to bypass
zones.
To exit a function and return to the Ready state,
press [#].
To select a function press [ ].
Important Note: Test system weekly and have any system trouble
conditions corrected by your alarm installer.

PC5508Z LED Keypad

9 9