Canon EOS 5Ds Instruction Manual page 472

Troubleshooting Guide
The access lamp still lights or blinks
even when the power switch is <2>.
If the power is turned off while an image is being recorded to the card, the
access lamp will remain on or continue to blink for a few seconds. When
the image recording is completed, the power will turn off automatically.
[Does this battery/do these batteries display the Canon logo?]
is displayed.
Do not use any battery other than a genuine Battery Pack LP-E6N/LP-E6.
Remove and install the battery again (p.42).
If the battery contacts are dirty, use a soft cloth to clean them.
The battery becomes exhausted quickly.
Use a fully-charged battery
The battery performance may have degraded. See [53: Battery info.]
to check the battery's recharge performance level (p.446). If the
battery performance is poor, replace the battery with a new one.
The number of possible shots will decrease with any of the following
operations:
• Pressing the shutter button halfway for a prolonged period.
• Activating the AF frequently without taking a picture.
• Using the lens's Image Stabilizer.
• Using the LCD monitor frequently.
• Continuing Live View shooting or movie shooting for a prolonged period.
• The Eye-Fi card's communication function is operating.
The camera turns off by itself.
Auto power off is in effect. If you do not want auto power off to take
effect, set [52: Auto power off] to [Disable] (p.69).
Even if [52: Auto power off] is set to [Disable], the LCD monitor will
still turn off after the camera is left idle for 30 min. (The camera's
power does not turn off.)
472
(p. )
40 .