Setup; Scope Of Delivery; Mains Connection; Connection Of Peripheral Devices - KERN ILT 12K0.1DM Operating Instructions Manual

7.2.1 Setup

Level balance with foot screws until the air bubble of the water balance is in the
prescribed circle.

7.2.2 Scope of delivery

Serial accessories:
• Balance
• Weighing plate
• Mains power supply
• Operating Manual
• Safety hood above control panel

7.3 Mains connection

Power is supplied via the external mains power supply. The stated voltage value
must be the same as the local voltage.
Only use original KERN mains power supplies. Using other makes requires consent
by KERN.

7.4 Connection of peripheral devices

Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they
are ideally tuned to your balance.

7.5 Initial Commissioning

A warming up time of 15 minutes after switching on stabilizes the measuring values.
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
ILT-BA-e-0612 13