Table of Contents
Advertisement
Select an address and corresponding interrupt for the first and the second serial ports. The settings
are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
Onboard Fast IR
This item allows you to Enabled Fast InfraRed (IR) function of the onboard I/O chip, when enabled
this function user must install driver the driver is in CD Pack\VIA\VIAFIR.
3-8
Power Management Setup
The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
ACPI Function
ACPI Suspend Type
Video Off Option
Video Off Method
MODEM Use IRQ
Power Button Function
Power after Power Failure
> Wake Up Events
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
ACPI Function
This item allows you to Enabled/Disabled the Advanced Configuration and Power Management
(ACPI). The settings are Enabled and Disabled.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank
(Default)
Blank Screen
DPMS
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
State After Power Failure
This determines the manner when the power recovery after power failure. The setting are:
Always Off, Always On.
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
Enabled
Enabled
Always Off
V/H SYNC+Blank
3
Instant Off
Always Off
Press Enter
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
Menu Level >
27
Item Help
Advertisement
Table of Contents
