Monarch 7411 Operating Instructions Manual page 54

4. Print a test label. See Chapter 1, "Getting Started" for more information.
Press the print server test button for about a second and a label should
print.
Use 6-inch long supply. If you are using supply that is shorter than 6
inches long, temporarily change your supply type to "continuous" to
print the entire test label. After printing the test label, change your
supply type to your previous setting.
If a label does not print, check the printer's display to see if it shows
a receiving status. If so, press Escape to exit receiving mode. Once
you see "Online Ready" on the display, print a test label again. If
this does not print or the printer does not display "Online Ready," the
unit is locked up. Turn off the printer, wait fifteen seconds and then
turn it back on.
If the printer displays "Online Ready," but is not printing, verify that
the parallel port settings did not change. The Parallel Port setting
should be "Internal" and the Mode setting should be "IEEE1284".
(From the Main Menu, select Setup, Port Settings, Parallel Comm.,
Port and Mode.)
5. On the test label, verify your IP and WiFi settings. If using an Ethernet
cable, the "Wired/Wireless:" value should be "WIRED". If using RF, the
setting should be "WIRELESS".
Check the "Actual SSID" and the "WiFi Sig Qual". Is the actual SSID
correct? Is the signal quality greater than zero? If the signal quality
is 0, you lost connection with the access point. If it is very low, you
may be experiencing interference or are very close to being out of
range or an access point. A value of 100 is the best you can have
for signal quality. You can probably operate at a minimum of 60, but
the number of retries is likely to increase.
Telnet to the printer.
6.
Note: If the print server has been reset, you may need to re-enable Telnet.
Once you have verified connectivity, Telnet to the printer. This gives
you access to console operation of the printer. Press Enter (on your
host) to get the "#" prompt and enter "access" as the password.
Press Enter to by-pass the user name. Once here, you have verified
operation to the print server.
5-2 Ethernet Operating Instructions